Information about Tft Lcd

A thin film transistor liquid crystal display (TFT-LCD) is a variant of liquid crystal display (LCD) which uses thin film transistor (TFT) technology to improve image quality. TFT LCD is one type of active matrix LCD, though it is usually synonymous with LCD. It is used in televisions, flat panel displays and projectors.

Construction

Normal liquid crystal displays like those found in calculators have direct driven image elements – a voltage can be applied across one segment without interfering with other segments of the display. This is impractical for a large display with a large number of picture elements (pixels), since it would require millions of connections - top and bottom connections for each one of the three colors (red, green and blue) of every pixel. To avoid this issue, the pixels are addressed in rows and columns which reduce the connection count from millions to thousands. If all the pixels in one row are driven with a positive voltage and all the pixels in one column are driven with a negative voltage, then the pixel at the intersection has the largest applied voltage and is switched. The problem with this solution is that all the pixels in the same column see a fraction of the applied voltage as do all the pixels in the same row, so although they are not switched completely, they do tend to darken. The solution to the problem is to supply each pixel with its own transistor switch which allows each pixel to be individually controlled. The low leakage current of the transistor also means that the voltage applied to the pixel does not leak away between refreshes to the display image. Each pixel is a small capacitor with a transparent ITO layer at the front, a transparent layer at the back, and a layer of insulating liquid crystal between.

The circuit layout of a TFT-LCD is very similar to the one used in a DRAM memory. However, rather than building the transistors out of silicon which has been formed into a crystalline wafer, they are fabricated from a thin film of silicon deposited on a glass panel. Transistors take up only a small fraction of the area of each pixel, and the silicon film is etched away in the remaining areas, allowing light to pass through.

The silicon layer for TFT-LCDs is typically deposited using the PECVD process from a silane gas precursor to produce an amorphous silicon film. Polycrystalline silicon is also used in some displays where higher performance is needed from the TFTs, typically in very high resolution displays or ones where performing some data processing on the display itself is desirable. Both amorphous and polycrystalline silicon TFTs have very poor performance compared with transistors fabricated from single-crystal silicon.

Types

TN + film

The 'TN (twisted nematic) + film' display is the most common consumer display type, due to its low production cost and wide development. The pixel response time on modern TN panels is sufficiently fast to most users to avoid the shadow-trail and ghosting artifacts that were a cause for complaint in the past. This fast response time has been a heavily marketed aspect of TN displays, although in most cases this number does not reflect performance across the entire range of possible color transitions. Traditional response times were quoted as an ISO standard black > white transition and did not reflect the speed of transitions across grey tones (a much more common transition for liquid crystals to make in practice). Modern use of RTC (Response Time Compensation – Overdrive) technologies has allowed manufacturers to significantly reduce grey to grey (G2G) transitions, while the ISO response time remains practically unchanged. Response times are now quoted in G2G figures, with 4ms and 2ms now being commonplace for TN Film based models. This marketing strategy, combined with the relatively lower cost of production for TN panels, has led to the dominance of TN in the consumer market.

The TN display suffers from limited viewing angles, especially in the vertical direction, and most are unable to display the full 16.7 million colors (24-bit truecolor) available from modern graphics cards. These particular panels, with 6 bits per color channel as opposed to 8, can approach 24-bit color using a dithering method which combines adjacent pixels to simulate the desired shade. They can also use FRC (Frame Rate Control), the less conspicuous of the two. FRC quickly cycles pixels over time to simulate a given shade. These color simulation methods are noticeable to most people and discomforting for some. FRC tends to be most noticeable in darker tones. Dithering has the tendency to appear as if the individual pixels of the LCD were actually visible. Overall, color reproduction and linearity on TN panels is poor. Shortcomings in display color gamut (often referred to as a percentage of the NTSC 1953 color gamut) can also be attributed to backlighting technology. It is not uncommon for displays with CCFL (Cold Cathode Fluorescent Lamps) based lighting to range from 40% to 76% of the NTSC color gamut, whereas displays utilizing white LED backlights may extend past 100% of the NTSC color gamut – a difference quite perceivable by the human eye.

With LCD displays, the transmittance of a pixel is typically not linear with the applied voltage,^[1] and the sRGB standard for computer monitors requires a specific nonlinear dependence of the amount of emitted light as a function of the RGB value.

IPS

IPS (in-plane switching) was developed by Hitachi in 1996 to improve on the poor viewing angles and color reproduction of TN panels. Most also support true 8-bit color. These improvements came at a loss of response time, which was initially on the order of 50ms. IPS panels were also extremely expensive.

IPS has since been superseded by S-IPS (Super-IPS, Hitachi in 1998), which has all the benefits of IPS technology with the addition of improved pixel refresh timing. Though color reproduction approaches that of CRTs, the contrast ratio remains relatively weak. S-IPS technology is widely used in panel sizes of 20" and above. LG and Philips remain one of the main manufacturers of S-IPS based panels.

AS-IPS – Advanced Super IPS, also developed by Hitachi in 2002, improves substantially on the contrast ratio of traditional S-IPS panels to the point where they are second only to some S-PVAs. AS-IPS is also a term used for NEC displays (e.g., NEC LCD20WGX2) based on S-IPS technology, in this case, developed by LG.Philips.

A-TW-IPS – Advanced True White IPS, developed by LG.Philips LCD for NEC, is a custom S-IPS panel with a TW (True White) color filter to make white look more natural and to increase color gamut. This is used in professional/photography LCDs.

H-IPS – Released sometime late 2006, was the H-IPS panel which is an evolution of the IPS panel which improves upon it’s predecessor, the S-IPS panel. The H-IPS panel can be seen in the NEC LCD2690WUXi and the Mitsubishi RDT261W 26″ LCD monitors and also Apple's newest Aluminum 24" iMacs.

So to sum up, the pros/cons of the H-IPS over the S-IPS:

Pros:

• Much less backlight bleed.
• No purple hue visible at an angle
• Backlight bleed improves looking at an angle
• Less noise or glitter seen on the panel surface (smoother surface)

Cons:

• Still some backlight bleed in areas that are green.
• Viewing angles may have sacrificed in order to improve pros.

Fringe Field Switching is a technique to accomplish wider viewing angle and transmittance on IPS displays. ^[2]

MVA

MVA (multi-domain vertical alignment) was originally developed in 1998 by Fujitsu as a compromise between TN and IPS. It achieved fast pixel response (at the time), wide viewing angles, and high contrast at the cost of brightness and color reproduction. Modern MVA panels can offer wide viewing angles (second only to S-IPS technology), good black depth, good color reproduction and depth, and fast response times thanks to the use of RTC technologies. There are several "next generation" technologies based on MVA, including AU Optronics' P-MVA and A-MVA, as well as Chi Mei Optoelectronics' S-MVA.

Analysts predicted that MVA would corner the mainstream market, but instead, TN has risen to dominance. A contributing factor was the higher cost of MVA, along with its slower pixel response (which rises dramatically with small changes in brightness). Cheaper MVA panels can also use dithering/FRC.

PVA

PVA (patterned vertical alignment) and S-PVA (super patterned vertical alignment) are alternative versions of MVA technology offered by Samsung. Developed independently, it offers similar features to MVA, but boasts very high contrast ratios such as 3000:1. Value-oriented PVA panels also use dithering/FRC. S-PVA panels all use true 8-bit color electronics and do not use any color simulation methods. PVA and S-PVA can offer good black depth, wide viewing angles and S-PVA can offer additionally fast response times thanks to modern RTC technologies.

Electrical interface

External consumer display devices like an TFT LCD uses mostly an analogue VGA connection, while newer models mostly feature a digital interface like DVI or HDMI as well.

Inside an external display device there is a controller board that will convert VGA, DVI, HDMI, CVBS etc.. to something that the display panel can make use of. Inside a laptop the graphics chip will directly produce a signal suitable for connection to the builtin TFT.

The lowlevel interface of STN, DSTN or TFT display panels use either single ended TTL 5V or TTL 3,3V that transmit Pixel clock, Horizontal sync, Vertical sync, Digital red, Digital green, Digital blue in parallel. Some models also feature input enable, horizontal scan direction and vertical scan direction signals.

New and large TFT displays often use LVDS or TMDS signaling that just stuff the control and RGB bits into a number of transmission lines.

Backlight is sometimes controlled by varying a few volts DC to the backlight highvoltage (1.3kV) inverter. In other cases it's either controlled by a potentiometer or fixed. The bare display panel requires a specific resolution determined by the pixel matrix set at manufacture. And this is also one of the factors why laptop displays can't be reused directly with an ordinary computer graphics card or as a television, because it lacks a hardware rescaler (often using some discrete cosine transform).

Safety

The liquid crystals inside the display are poisonous. It must not be ingested, touch your skin or clothes. If spills occur due to a cracked display, wash off immediately with soap and water. ^[3]

Display industry

Due to the very high cost of building TFT factories, there are few major OEM panel vendors for large display panels. The top six glass panel suppliers are as follows:

1. LG.Philips
2. AU Optronics
3. S-LCD Corporation (a Samsung/Sony joint venture)
4. Chi Mei Optoelectronics
5. Sharp Corporation
6. Samsung

Raw LCD TFT panels are usually factory-sorted into three categories, with regard to the number of dead pixels, backlight evenness and general product quality. Additionally, there may be up to +/- 2ms maximum response time differences between individual panels that came off the same assembly line on the same day. The poorest-performing screens are then sold to no-name vendors or used in "value" TFT monitors (often marked with letter V behind the type number), the medium performers are incorporated in gamer-oriented or home office bound TFT displays (sometimes marked with the capital letter S), and the best screens are usually reserved for use in "professional" grade TFT monitors (often marked with letter P or S after their type number).

Value TFT screens and most 15 inch sized LCDs usually lack a digital input like DVI connector, so their future proofing may be limited. Most displays larger than 17 inch have both an VGA analog input and a DVI digital input sockets. Almost all professional screens include a DVI socket and some also include a pivot mode for portrait-mode display.

References

See also

• Liquid crystal display television
• Transreflective liquid crystal display, for adaptation to environment brightness

External links

• TFT specifications explained, TFTCentral.co.uk
• TFT panel database / search tool, TFTCentral.co.uk
• LCD Panels with Response Time Compensation, X-bit labs, December 20 2005
• Contemporary LCD Monitor Parameters and Characteristics, X-bit labs, October 26 2004
• Gaming issues with TFT LCD Displays, Digital Silence, August 10 2004
• What is TFT LCD, Plasma.com – detailed description of the technology inside a TFT LCD