Information about History Of Mobile Phones

Mobile phone and data standards

GSM / UMTS Family

2G GSM GPRS HSCSD

3G EDGE (EGPRS) W-CDMA UMTS (3GSM) FOMA UMTS-TDD TD-CDMA TD-SCDMA HSPA HSDPA HSUPA HSPA+

Pre-4G UMTS Revision 8 LTE HSOPA (Super 3G)

cdmaOne / CDMA2000 Family

2G cdmaOne

3G CDMA2000 EV-DO

Pre-4G UMB

Other Technologies

0G PTT MTS IMTS AMTS OLT MTD Autotel / PALM ARP

1G NMT AMPS / TACS / ETACS Hicap CDPD Mobitex DataTAC

2G iDEN D-AMPS PDC CSD PHS WiDEN

3G GAN

Pre-4G iBurst HIPERMAN WiMAX WiBro (Mobile WiMAX)

Frequency bands SMR Cellular PCS

The history of mobile phones can be traced back to devices that are unrecognizable in today's GSM dominated world.

Early Years

Mobile rigs were the beginning of cell phones for use in vehicles such as taxicab radios, two way radios in police cruisers, and the like. A large community of mobile radio users, known as the mobileers, popularized the technology that would eventually give way to the mobile phone. Originally, mobile phones were permanently installed in vehicles, but later versions such as the so-called transportables or "bag phones" were equipped with a cigarette lighter plug so that they could also be carried, and thus could be used as either mobile or as portable phones.

In December 1947, Douglas H. Ring and W. Rae Young, Bell Labs engineers, proposed hexagonal cells for mobile phones.^[1] Philip T. Porter, also of Bell Labs, proposed that the cell towers be at the corners of the hexagons rather than the centers and have directional antennas that would transmit/receive in 3 directions (see picture at left) into 3 adjacent hexagon cells.^{[2] [3]} The technology did not exist then and the frequencies had not yet been allocated. Cellular technology was undeveloped until the 1960s, when Richard H. Frenkiel and Joel S. Engel of Bell Labs developed the electronics.

In Europe, radio telephony was first used on the first-class passenger trains between Berlin and Hamburg since 1926. At the same time, radio telephony was introduced on passenger airplanes for air traffic security. Later radio telephony was introduced on a large scale in German tanks during the Second World War. After the war German police in the British zone of occupation first used disused tank telephony equipment to run the first radio patrol cars. In all of these cases the service was confined to specialists that were trained to use the equipment. In the early 1950s ships on the Rhine were among the first to use radio telephony with an untrained end customer as a user.

Recognizable mobile phones with direct dialing have existed at least since the 1950s. In the 1954 movie Sabrina, the businessman Linus Larrabee (played by Humphrey Bogart) makes a call from the phone in the back of his limousine.

The first fully automatic mobile phone system, called MTA (Mobile Telephone system A), was developed by Ericsson and commercially released in Sweden in 1956. This was the first system that didn't require any kind of manual control, but had the disadvantage of a phone weight of 40 kg (88 lbs). MTB, an upgraded version with transistors, weighing 9 kg {19.8 lbs), was introduced in 1965 and used dual-tone multifrequency signaling. It had 150 customers in the beginning and 600 when it shut down in 1983.

In 1967, each mobile phone had to stay within the cell area serviced by one base station throughout the phone call. This did not provide continuity of automatic telephone service to mobile phones moving through several cell areas. In 1970 Amos E. Joel, Jr., another Bell Labs engineer,^[4] invented an automatic "call handoff" system to allow mobile phones to move through several cell areas during a single conversation without loss of conversation.

In December 1971, AT&T submitted a proposal for cellular service to the Federal Communications Commission (FCC). After years of hearings, the FCC approved the proposal in 1982 for Advanced Mobile Phone Service (AMPS) and allocated frequencies in the 824-894 MHz band.^[5] Analog AMPS was superseded by Digital AMPS in 1990.

One of the first truly successful public commercial mobile phone networks was the ARP network in Finland, launched in 1971. Posthumously, ARP is sometimes viewed as a zero generation (0G) cellular network, being slightly above previous proprietary and limited coverage networks.

On April 3, 1973, Motorola employee Dr. Martin Cooper placed a call to rival Joel Engel, head of research at AT&T's Bell Labs, while walking the streets of New York City talking on the first Motorola DynaTAC prototype. Motorola has a long history of making automotive radio, especially two-way radios for taxicabs and police cruisers.

In 1978, Bell Labs launched a trial of first commercial cellular network in Chicago using AMPS [1].

First Generation

Main article: 1G

The first handheld mobile phone to become commercially available to the US market was the Motorola DynaTAC 8000X, which received approval in 1983. Mobile phones began to proliferate through the 1980s with the introduction of "cellular" phones based on cellular networks with multiple base stations located relatively close to each other, and protocols for the automated "handover" between two cells when a phone moved from one cell to the other. At this time analog transmission was in use in all systems. Mobile phones were somewhat larger than current ones, and at first, all were designed for permanent installation in vehicles (hence the term car phone). Soon, some of these bulky units were converted for use as "transportable" phones the size of a briefcase. Motorola introduced the first truly portable, handheld phone. These systems (NMT, AMPS, TACS, RTMI, C-Netz, and Radiocom 2000) later became known as first generation (1G) mobile phones.

Second Generation

Main articles: 2G, 2.5G, and 2.75G

In the 1990s, 'second generation' (2G) mobile phone systems such as GSM, IS-136 ("TDMA"), iDEN and IS-95 ("CDMA") began to be introduced. The first digital cellular phone call was made in the United States in 1990, in 1991 the first GSM network (Radiolinja) opened in Finland. 2G phone systems were characterized by digital circuit switched transmission and the introduction of advanced and fast phone to network signaling. In general the frequencies used by 2G systems in Europe were higher though with some overlap, for example the 900 MHz frequency range was used for both 1G and 2G systems in Europe and so such 1G systems were rapidly closed down to make space for 2G systems. In America the IS-54 standard was deployed in the same band as AMPS and displaced some of the existing analog channels.

Coinciding with the introduction of 2G systems was a trend away from the larger "brick" phones toward tiny 100–200g hand-held devices, which soon became the norm. This change was possible through technological improvements such as more advanced batteries and more energy-efficient electronics, but also was largely related to the higher density of cellular sites caused by increasing usage levels.

Third Generation

Main article: 3G

Not long after the introduction of 2G networks, projects began to develop third generation (3G) systems. Inevitably there were many different standards with different contenders pushing their own technologies. Quite differently from 2G systems, however, the meaning of 3G has been standardized in the IMT-2000 standardization processing. This process did not standardize on a technology, but rather on a set of requirements (2 Mbit/s maximum data rate indoors, 384 kbit/s outdoors, for example). At that point, the vision of a single unified worldwide standard broke down and several different standards have been introduced.

During the development of 3G systems, 2.5G systems such as CDMA2000 1x and GPRS were developed as extensions to existing 2G networks. These provide some of the features of 3G without fulfilling the promised high data rates or full range of multimedia services. CDMA2000-1X delivers theoretical maximum data speeds of up to 307 kbit/s. Just beyond these is the EDGE system which in theory covers the requirements for 3G system, but is so narrowly above these that any practical system would be sure to fall short.

At the beginning of the 21st century, 3G mobile phone systems such as UMTS and CDMA2000 1xEV-DO have now begun to be publicly available. The final success of these systems is still to be determined.

Live streaming of radio and television [2] to 3G handsets is one future direction for the industry, with companies from Real [3] and Disney [4] recently announcing services.

Patents

• U.S. Patent 3,663,762  -- Cellular Mobile Communication System -- Amos Edward Joel (Bell Labs), filed Dec 21, 1970, issued May 16, 1972
• U.S. Patent 3,906,166  -- Radio Telephone System (Dyna-Tac) -- Martin Cooper et al. (Motorola), filed Oct 17, 1973, issued September 16, 1975
• U.S. Patent 4,399,555  -- Cellular Mobile Radiotelephone System -- Verne MacDonald, Philip Porter, Rae Young, (Bell Labs) filed April 28, 1980, issued August 16, 1983
• U.S. Patent 5,265,158  -- Construction of a stand alone portable telephone unit -- Jouko Tattari (Nokia), filed May 11, 1992, issued November 23, 1993
• U.S. Patent 5,722,067  -- Security cellular telecommunications system -- Douglas Fougnies et al (Freedom Wireless), filed Dec 1994, issued February 24, 1998
• U.S. Patent 5,841,856  -- Hands-free telephone set -- Yoshiyuki Ide (NEC), filed May 21, 1997, issued November 24, 1998

See also

• Mobile phone
• Personal Communications Service PCS

Notes

References

• Tom Farley, "The Cell-Phone Revolution", Invention & Technology, Winter 2007, vol. 22:3, pages 8-19.

External links

• 1947 memo by Douglas H. Ring proposing hexagonal cells
• The history of cellular telephones in the US
• Mobile Forum
• Cell Phone Basics
• Cellular Convergence: Evolution, Revolution and Speculation